How to solve laser engraving fuzzy
2016-08-22LASER Engraving machine in the time always there is a shadow of the phenomenon, the performance of the fuzzy image, image is not clear, the lines are too thick, change the engraving power is invalid
Most of the reasons for this problem is due to the reverse gap in the software installation did not fill in, or the speed of the use of the reverse gap is not debug.
Please fill in the following steps to install new software or replace the computer:
1 open the software settings (as shown below
一
二
As shown in the picture as shown in the digital instructions for operation, which is in the parameters of the random generator storage devices inside, there is a EXCAL table, playing, open the specific parameters such as the following figure
三
